Changing the water filter of your refrigerator when it needs to be replaced makes it easy to always keep water and ice tasting great. Replacing the water filter is easy and you can do it yourself.

  • Replace using only LG Brand filters that are not expired. Avoid using Non-LG Brand Water filter and using a water filter for more than recommended period (6 months)
  • Use of consumable products that are NOT Authorized by LG is not covered under Warranty
  • LG recommends replacing the water filter every six months. If you have been using the filter for more than 6 months, issues caused by this are not covered under Warranty



LT1000P / LT900x3 (3-Stage Filters) / LT800P / LT700P / LT600P / LT500P


1. Remove the top shelf.

If the top shelf, which is located below the water filter, is in the highest position, it will need to be removed. This can be done in two simple steps:

  • Tilt up the front of the shelf and lift it.
  • Pull the shelf out.
top_shelf

2. Remove old water filter.

Pull the old water filter downward and turn it counter-clockwise to pull it out. Make sure to rotate the filter down completely before pulling it out of the manifold hole.

3. Install new water filter.

Take a new water filter out of its packaging and remove the protective cover from the o-rings. With the filter tabs in the horizontal position, push the new filter into the manifold hole, rotate it up into place, and close the cover.

4. Remove trapped air.

Now that the filter is replaced, dispense 2.5 gallons of water to remove trapped air and contaminants from the system. Depress and release the dispenser pad for cycles of 30 seconds ON and 60 seconds OFF, rather then dispensing continuously.

If your model is equipped with a water filter indicator on the display, press and hold the FILTER button or RESET button for approximately 5 seconds to reset the filter indicator.